This site will look much better in a browser that supports web standards,but it is accessible to any browser or Internet device.

Title.gif

WCR Data Processing and Data Format

Real-Time DSP

 WCR is software controlled and all outputs are recorded in digital form by the Data Acquisition System (DAQ). WCR DAQ performs the following operations depending on the operational mode:

  • Processing
    • Pulse averaging
    • Calibrate received power in mW
    • Pulse-pair processing
    • 16- to 512-point FFT and power spectrum calculation
    • Stores data on a hard disk in custom WCR format

  • Outputs
    • Noise channels (H and V receivers)
    • Transmitted power samples (up to about 30 samples per second)
    • Backscatter Data Profiles (algorithm dependent)
    • Maximum number of recorded profiles per second (pps) depends on the algorithm (typically between 20 and 30 pps)

    Post Flight Processing

      After a flight the raw data are archived in its native WCR format.
      Post flight processing is available for:
    • Quality control of the radar performance
    • Producing reflectivity images in dBZ (based on preliminary calibration constants); images are available on the WCR project web page
    • Visualization of reflectivity, uncorrected/corrected mean Doppler velocity

Post Experiment Processing
  • Transform the Doppler data to ground-relative coordinates: remove velocity components due to aircraft motion
  • Calculate WCR products(Z,Doppler velocity)
  • Archive WCR products in NetCDF format
    The final data product is usually ready for further analysis and distribution no later than 2-3 months after an experiment.

Processed Data Format

Data Availability
    Data from past experiments are available to researchers upon request.